F8620 11 模拟量扩展模块HIMA
产品介绍
型号名称： F8620/11 模拟量扩展模块
对于初始设定模式下实施控制所需要的必须设定项目、使用频率较高的项目、更改频率较高的设定项目归为一组，只要设定好这些内容即可开始执行控制。所以，初次设定更容易。
配备有简易的程序功能
通过设定9个阶段的程序步，即可实施简易的程序控制。通过时间，分别设定目标，从而可实施任意的温度控制。
例：从开始实施程序控制时
(1)： 实施控制，使其在1小时后达到200℃
(2)： 使其在2小时候仍维持在200℃
(3)： 实施控制，使其在30分钟后达到300℃
配备有简易的程序功能
对于热容量较小的物体，也可实施控制
采样周期高达125ms，是以往产品的1/2倍。利用2倍的响应性，可对热容量较小的物体等进行控制。
配备有上升沿自调谐功能
配备有上升沿自调谐功能，仅利用一次性的升温动作，即可求出PID常数。无法利用自调谐求出常数的情况下，也可求出常数。
由于不执行ON/OFF动作，因此不会打乱控制方式。
配备有上升沿自调谐功能
其他特点
采用大型显示和密钥长度，提高可视性和操作性。
进深约为60mm的紧凑设计，可实现省空间。
输出直流电流，可用作简易的信号转换器。
Product introduction
Model name: F8620/11
The items that must be set, the items with high frequency of use and the setting items with high frequency of change required for the implementation of control in the initial setting mode are grouped into a group. As long as these contents are set, the control can be executed. Therefore, the initial setting is easier.
Equipped with simple program function
Simple program control can be implemented by setting 9 stages of program steps. By specifying the time and setting the targets respectively, arbitrary temperature control can be implemented.
Example: from the beginning of program control
(1) : control to reach 200 ℃ after 1 hour
(2) : keep it at 200 ℃ for 2 hours
(3) : control to reach 300 ℃ after 30 minutes
Equipped with simple program function
For objects with small heat capacity, control can also be implemented
The sampling period is up to 125ms, which is 1 / 2 times that of previous products. With twice the responsiveness, objects with small heat capacity can be controlled.
Equipped with rising edge self tuning function
Equipped with rising edge self-tuning function, the PID constant can be obtained only by one-time heating action. If the constant cannot be obtained by self tuning, the constant can also be obtained.
Since the on / off action is not executed, the control mode will not be disturbed.
Equipped with rising edge self tuning function
Other features
Large display and key length are adopted to improve visibility and operability.
The compact design with a depth of about 60mm can save space.
The output DC current can be used as a simple signal converter.
