BENTLY 3500/44-01-00 推力位置通道（非支架输入/输出模块）
调整零位电压。单击此按钮时，一个实用程序将启动
帮助您设置直接零位电压。由于此实用程序提供活动
来自3500机架的反馈，需要与机架连接。提到
第5.2节（调整比例因子和零点位置）。
传感器
以下传感器类型可用于推力位置通道（非支架输入/输出模块）：
3300-5mm前置器
3300-8mm前置器
7200-5mm前置器
7200-8mm前置器
7200-11mm前置器
7200-14mm前置器
3000（-18V）前置器
3000（-24V）前置器
3300 RAM前置器
3300-16毫米HTPS
非标准
以下传感器类型可用于推力位置通道
（安全栅输入/输出模块）：
3300-5mm前置器
3300-8mm前置器
7200-5mm前置器
7200-8mm前置器
3300 RAM前置器
非标准
“自定义”按钮
用于调整传感器的比例因子。如果非标准选择为
传感器类型，OK Limits（正常限值）也可以调整。非标准
换能器的比例因子必须在85和230 mV/mil之间。此外，必须
在OK（正常）上限和下限之间至少为2伏。
Adjust the Zero Position voltage. When this button is clicked a utility starts that
helps you set the direct zero position voltage. Since this utility provides active
feedback from the 3500 rack, a connection with the rack is required. Refer to
Section 5.2 (Adjusting the Scale Factor and the Zero Position).
Transducer
The following transducer types are available for the Thrust Position Channel (nonbarrier I/O module):
3300 - 5mm Proximitor
3300 - 8mm Proximitor
7200 - 5mm Proximitor
7200 - 8mm Proximitor
7200 - 11mm Proximitor
7200 - 14mm Proximitor
3000 (-18V) Proximitor
3000 (-24V) Proximitor
3300 RAM Proximitor
3300 - 16mm HTPS
Nonstandard
The following transducer types are available for the Thrust Position Channel
(barrier I/O module):
3300 - 5mm Proximitor
3300 - 8mm Proximitor
7200 - 5mm Proximitor
7200 - 8mm Proximitor
3300 RAM Proximitor
Nonstandard
Customize button
Used to adjust the Scale Factor for transducers. If Non-standard is selected as
the transducer type, the OK Limits can also be adjusted. The Non-standard
transducer's scale factor must be between 85 and 230 mV/mil. Also, there must
be at least 2 volts between the Upper and Lower OK Limits.
