DS200TBQBG1A工控卡件PLC/DCS备件系统

                                                产品详情资料：

如果继电器的连接、矢量组匹配和变压比校正正确，则以下内容适用于每相：-相电流相同高-差电流为0%-高压和低压侧相电流的相位差为0°-同侧相电流之间的相位差是120°。

模块功能? 完全软件可配置，无需设置模块跳线? 单独启用或禁用通道? 夹紧和报警限值? 警报的锁定? 可配置输出偏置? 用户定义的缩放? 高报警、低报警检测和报告? 模块故障报告? 可配置的保持上次状态或输出默认值? 支持逻辑程序中的诊断点故障触点? 用于未来升级的闪存? 模块状态、现场状态和TB指示灯? 正负变化率报警? 端子板插入或移除检测输出范围电流：0至20mA，4至20mA电压：+/-10V，0至10V背板功率要求模块IC695ALG004内3.3V功耗时375 mA：4.9瓦GE Multilin UR8FV：7瓦热降额GE Multilin UR8FV：无GE Multilin UR8FV：电压模式：无电流模式：见下一页。

                                               产品英文详情资料：

If the connection, vector group matching and the transformation ratio corrections of the relay are correct the following applies to each phase: - the phase currents are equally high - the differential currents are 0% - the phase differences of the HV and LV side phase currents are 0° - the phase differences between the phase currents on the same side are 120°.

Module Features ? Completely software-configurable, no module jumpers to set ? Individually enable or disable channels ? Clamping and Alarm Limits ? Latching of Alarms ? Configurable output bias ? User-defined scaling ? High alarm, low alarm detection and reporting ? Module fault reporting ? Configurable Hold Last State or Output Defaults ? Supports diagnostic point fault contacts in the logic program ? Flash memory for future upgrades ? Module Status, Field Status, and TB LEDs ? Positive and negative Rate of Change Alarms ? Terminal Block insertion or removal detection Output Ranges Current: 0 to 20mA, 4 to 20mA Voltage: +/- 10V, 0 to 10V Backplane Power Requirements 375 mA maximum at 3.3V Power Dissipation within Module IC695ALG704: 4.9 Watts maximumGE Multilin UR8FV: 7 Watts maximum Thermal Derating GE Multilin UR8FV: NoneGE Multilin UR8FV: Voltage mode: none Current mode: See next page.