ABB PM866 3BSE050200R1 报警消息在控制器中带有时间戳

如果从INSUM设备接收到的时间戳不正确，则显示这些字段。（参见

以下）。

为报警列表生成报警

控制器系统软件为中的报警和事件列表生成报警

如果参数

设备上的Generate Alarms（生成警报）设置为Enabled（启用）或Enabled Trip/Warning（启用跳闸/警告）或

已启用详细信息。

如果这次从INSUM设备接收到的时间戳是正确的（有效时间）

stamp用于生成的报警消息。如果不是，系统软件会标记

生成的报警消息与当前控制器时间。

在这种情况下，报警消息在控制器中带有时间戳。如果这次

准确度是足够的，这种方法可能是推荐的，因为它是

更易于配置。INSUM系统中不需要系统时钟。如果你让

系统软件生成警报，可以使用INSUM给出的时间戳

设备。如果使用INSUM系统时钟，这是一个更准确的时间

邮票

摘要报警，每个设备一个报警对象

生成警报=已启用意味着系统软件内部（无

需要INSUMReceive）从

INSUM设备。当从INSUM系统更新此变量时，系统

软件对内容进行评估。

如果被分类为警报的位（一个或多个）（例如不是“Started1”位）

设置，并且之前没有设置这样的位，系统软件生成一个警报

消息

如果接收到具有未设置报警分类位的变化的报警更新

再过一段时间，系统软件就会生成警报关闭消息

these fields if the time stamp received from the INSUM device is incorrect. (See

below).

Generating Alarms for Alarm Lists

The controller system software generates alarms for the alarm and event lists in the

system, based on the updates of the INSUM alarm information if the parameter

Generate Alarms on the device is set to Enabled or Enabled Trip/Warning or

Enabled Detailed.

If the time stamp received from the INSUM device is correct (a valid time) this time

stamp is used for the generated alarm message. If it is not, the system software tags

the generated alarm message with the current controller time.

In this case, the alarm messages are time stamped in the controller. If this time

accuracy is sufficient, this method is probably to be recommended because it is

easier to configure. No System Clock is needed in the INSUM system. If you let the

system software generate the alarms it can use the time stamp given by the INSUM

devices. If the INSUM System Clock is used this is a much more accurate time

stamp.

Summary Alarms, One Alarm Object Per Device

Generate Alarms = Enabled means that the system software internally (without

needing INSUMReceive) creates a subscription of the alarm variable from the

INSUM device. When this variable is updated from the INSUM system, the system

software evaluates the content.

If a bit (one or more) which is classified as an alarm (e.g. not the bit "Started1") is

set and no such bit previously was set, the system software generates one alarm

message.

If an alarm update is received with the change that no alarm classified bits are set

any more, the system software generates the alarm-off message