ABB UFC762AE101电缆压入拼接套管

在电气室和操作员站之间使用双工硅纤维，如果适用，可从操作员处使用

第一站到第二站。

请注意，本手册的订购页中列出了带连接器的现成电缆。如果这些电缆

使用时，安装无故障。

订单页面中列出的电缆可以与3ASC25H266双工光拼接装置DATX 140连接。

DATX 140在安装导轨上占据20mm的宽度。将一根电缆的“T”光纤与“R”光纤连接

只需将另一根电缆压入拼接套管，直到发出咔嗒声。对另外两个做同样的事情

另一个套管中的纤维。

连接电缆的总长度不得超过150 m。接头数量不得超过四个。

对于热金属应用，应使用外部保护软管。制造商ALMI，Postfach

1302274330德国Mülheim Ruhr 13（Saarn），电话+49 208 486186，传真+49 208 482528可提供

合适的软管。要求HY计划（无石棉）。多条电缆可以在同一根软管内。可提供12毫米的直径。

对于超过150米的距离和回转起重机的“纤维滑环”：请联系ABB。

与传统电缆相比，光纤具有减小电缆管道和接线盒尺寸的优点，

以及降低在起重机上进行焊接时损坏电子设备的风险。

Duplex silicon fiber is used between the electrical room to the operator station, and if applicable from the operator 

first station to the second station. 

Note that ready-made cables with connectors are listed in the Order page of this Manual. If these cables 

are used, the installation is trouble-free. 

The cables listed in the Order page can be joined with 3ASC25H266 Duplex opto splice unit DATX 140. 

DATX 140 occupies 20 mm width on the mounting rail. Connect the "T" fiber of one cable with the "R" fiber 

of the other cable only by pressing it into the splice bushing until it clicks. Do the same with the other two 

fibers in the other bushing. 

The sum of length of joined cables shall not exceed 150 m. Number of joints shall not exceed four. 

For hot metal applications an outer protection hose should be used. The manufacturer ALMI, Postfach 

130227, 4330 Mülheim-Ruhr 13 (Saarn), Germany, phone +49 208 486186, fax +49 208 482528 can supply 

suitable hoses. Ask for the HY program (asbestos-free). Several cables can be inside the same hose. Diameters from 12 mm are available.

For distances over 150 m and "fiber slip-rings" for slewing cranes: Contact ABB. 

The fiber has the advantage over conventional cable that is reduces the size of the cable ducts and junction boxes, 

as well as reducing the risk of destroying the electronic equipment when welding is done on the crane.