DS200TCRAG1AAA 可控硅模块/工控卡件PLC/DCS备件模块

产品标题: DS200TCRAG1AAA 可控硅模块/工控卡件PLC/DCS备件模块

型号：DS200TCRAG1AAA

品牌：GE

                                                    产品详情资料：

每个通道能够将15至16位（取决于所选范围）二进制数据转换为模拟输出。所有八个通道每12毫秒更新一次。在当前模式下，模块向CPU报告每个通道的开路故障。当系统电源中断时，模块可以进入已知的***状态。只要向模块施加外部电源，每个输出将保持其***值或重置为零（如配置）。此模块可以安装在RX3i系统的任何I/O插槽中。隔离+24 VDC电源模块必须从外部电源接收其24 VDC电源。如果模块位于RX3i通用背板中，则可通过背板左侧的TB1连接器或直接在模块的接线板上连接外部电源。如果此模块位于扩展背板中，则外部电源必须连接到模块的接线盒。LED模块正常LED指示模块状态。用户电源LED指示外部+24 VDC电源是否存在且高于***水平。两个LED均由+5 VDC背板电源总线供电。

                                                      产品英文详情料:

Each channel is capable of converting 15 to 16 bits (depending on the range selected) of binary data to an analog output. All eight channels are updated every 12 milliseconds.In current modes, the module reports an Open Wire fault to the CPU for each channel. The module can go to a known last state when system power is interrupted. As long as external power is applied to the module, each output will maintain its last value or reset to zero, as configured. This module can be installed in any I/O slot of an RX3i system. Isolated +24 VDC Power The module must receive its 24 VDC power from an external source. If the module is located in an RX3i Universal Backplane, the external source can be connected via the TB1connector on the left side of the backplane or directly on the module’s terminal block. If this module is located in an Expansion Backplane, the external source must be connected to the module’s terminal block.LEDs The Module OK LED indicates module status. The User Supply LED indicates whether the external +24 VDC power supply is present and is above the minimum level. Both LEDs are powered from the +5 VDC backplane power bus.